Quck answer
Gas stoves with electronic ignition can sometimes malfunction, but they can be repaired. Here are some steps to repair the electronic ignition on a gas stove:
1. Check the power source: Make sure the stove is properly connected to a power outlet and that the circuit breaker or fuse is not tripped.
2. Clean the igniter: Remove any debris or residue from the igniter using a soft brush or cloth. This can improve the spark and ignition.
3. Replace the igniter: If cleaning doesn’t solve the issue, the igniter may need to be replaced. Consult the stove’s manual or contact a professional for guidance.
4. Test the gas supply: Ensure there is a steady supply of gas to the stove by checking the gas valve and connections.
5. Call a professional: If these steps don’t resolve the problem, it’s best to call a qualified technician to diagnose and repair the electronic ignition.
By following these steps, you can troubleshoot and repair the electronic ignition on a gas stove, ensuring it works properly and safely.
A majority of gas stoves have an electronic ignition system, which sparks the gas supply exiting from the burners. The sparking ignition can be activated through a small switch located on the front of the oven or the gas control panels. However, if the wiring system is damaged or the fuse is blown, the oven will not light up even after multiple attempts of ignition. In such cases, repairing the fuses and ignition systems can be simple and easy.
Step 1
Begin by unplugging the unit and turning off the gas supply at the saddle valve near the unit.
Step 2
Lift the oven hood to locate the ignitors near the burners. In case of sealed burners, the lid will not lift up. Clean any dirt or debris from the ignitor using a toothbrush and test the unit.
Step 3
If the ignitors do not work, pull the burner dials off the front of the unit.
Step 4
Using a screwdriver, remove the screws from the ends of the front cover, where the gas supply knobs are located. Take off the cover from the oven.
Step 5
Slide the wires off the burner valve switches and pull them off the burner valve by sliding the switch forward. The switch will have wires attached to it. Loosen the screws holding down the wires of the burner valve. Pull out the wires carefully. Place the wires in a new switch. Slide the new switch onto the burner valve. Replace the knob, turn on the gas supply and power, and ignite the burner.
Step 6
If the new switch doesn’t work, follow the switch wires into the oven to locate the module box, which is typically 2 inches by 3 inches. Pull out the wires from the module terminal by tugging on the wire connectors. Remove the screws from the old module and pull the module out. Insert the wires into the new module, matching the wire orientation as before. Reassemble the oven, turn on the electricity and gas, and ignite the burner.