Quck answer
Rejuvenate is a floor cleaner that is designed to restore and protect the shine of your floors. However, if you want to remove Rejuvenate from your floors, there are a few steps you can follow:
1. Start by sweeping or vacuuming the floor to remove any loose dirt or debris.
2. Mix a solution of warm water and a mild detergent.
3. Dip a mop or sponge into the soapy water and wring out the excess moisture.
4. Gently scrub the floor using circular motions, focusing on the areas with Rejuvenate.
5. Rinse the mop or sponge frequently in the soapy water to prevent spreading the Rejuvenate.
6. Once you have cleaned the entire floor, rinse it thoroughly with clean water.
7. Dry the floor with a clean towel or allow it to air dry completely.
By following these steps, you can effectively remove Rejuvenate from your floors and restore them to their original state.
Rejuvenate is a special polymer that claims to restore old floors and cabinetry. It is meant to enhance their shine and give them an altogether brand new look. But like other floor finishing products, Rejuvenate can build up a cloudy film on surfaces after some time. There are several ways to remove it, including using a floor stripper and an ammonia-based cleaner.
Step 1
To begin, clean the surface thoroughly by sweeping away debris and dirt that may interfere with the cleaning process. Use a vacuum to eliminate dust.
Step 2
Next, combine one cup of white vinegar with one gallon of warm water in a bucket. This solution can be used on both wood floors and vinyl. The acidic nature of vinegar will cut through the chemicals in Rejuvenate and lift it off the surfaces.
Step 3
Dunk a mop in the liquid and squeeze out the excess. Using too much cleaner can harm the wood floor panels.
Step 4
Mop the floors from one end of the room to the other, ensuring that you work in the same direction as the planks. Dip the mop in the solution as you go, to refresh it. Continue until the Rejuvenate is gone.
Step 5
If the Rejuvenate persists, try using a floor stripper. Use a stripper that is compatible with the type of flooring you have. Follow the instructions on the label.
Step 6
Allow the stipper to penetrate the floor for ten minutes. Scrub the floor using a nylon pad.
Step 7
For large floors, rent a floor buffer from a home improvement store. Attach a scrubbing pad to make the job easier.
Step 8
Finally, run a clean, wet mop over the floor to remove any traces of Rejuvenate. This will pick up residue that you may have missed.
Step 9
Rub the floor dry with a dry mop or towels.